The end-client just requested a last-minute layout change. The robot's end-of-arm-tooling has a wider swing than the initial CAD file showed. Now, the entire safety perimeter for the new automated
Think your welded fence was cheap? Wait until a forklift clips it, shutting down your entire robotic cell for a day. Or when an EHS audit flags your safety distances,
Your new palletizing robot hits its cycle time targets, but the "safety" barrier around it is a liability waiting to happen. A single dropped case, a minor forklift tap, or
Your CAD layout is perfect, but the factory floor has columns and odd angles. Is on-site cutting and welding your only option for guarding corners? This compromises safety compliance, project
Your conveyor is the artery of your operation, but every unprotected pinch point or hard-to-access motor is a ticking clock—counting down to the next costly line stoppage or OSHA-recordable incident.
Your new conveyor line is installed, but the guarding is threatening to derail your project timeline. Hot work permits, production halts for welding, and non-compliant cutouts are not an option
Your multi-station assembly line is a masterpiece of engineering. But if the safety guarding is an afterthought, it becomes the single biggest point of failure during the final EHS audit.
Your robot is down. The fault is deep inside the cell. Is your safety fence a fortress, locking your maintenance team out? Every minute of downtime bleeds project margins, but
Your multi-station assembly line project is on a tight deadline. The last thing you need is a guarding system that requires on-site welding, fails the end-client's EHS audit, or can't
Your multi-station assembly line is a dynamic, high-value asset. But is it being held hostage by static, welded-on-site guarding? The constant project delays from hot work permits, the failed EHS
JA 
EN 
DE 
RU 
PT 
ES 
IT 
