SGF Mdfence framed mesh panels and yellow posts enclosing an industrial machine area
SGF Mdfence machine guarding installation. The image illustrates framed mesh panels and fence layout; it is not a cut-edge detail.

Why Possible Site Trimming Must Be Resolved Before the Fence Ships

A long machine guarding fence run can meet real site conditions that were not visible in the first layout. In one proposal for approximately 500 m of Mdfence, the client said mesh panels might need to be cut during installation. The proposal did not treat that as permission to cut any panel anywhere: it identified an open engineering input that had to be estimated and supplied with the right parts.

For the integrator’s designer, project manager and sales manager, the decision belongs in the design review. If cutting is left as an informal site instruction, the team may arrive without enough fixing parts or without a safe way to finish the exposed mesh edge.

Turn the Cutting Possibility Into a Defined Allowance

  • Mark the locations where panels may need adjustment on the current fence layout; do not apply a blanket allowance to every run.
  • Estimate how many panels may be cut and how much adjustment is expected at each location.
  • Use that estimate to determine the quantity of spare connection parts and fixing hardware to pack.
  • Confirm who is authorized to make site cuts and who checks the finished edge before handover.
  • Record any unresolved dimensions or site measurements as open items rather than silently treating them as confirmed.

The source proposal specifically says that related parts should be provisioned according to the estimated adjustment quantity. It does not set a universal number of spare clamps, a standard cutting tolerance or a general approval procedure. Those details need to be agreed for the actual installation.

Specify the Cut-Edge Protection With the Mesh Panel

The proposal describes two edge-protection options for a cut mesh edge. One is a rubber covering over a stainless-steel core; the other is a slotted angle trim fitted over the cut edge. Both are intended to cover the exposed edge. The choice should be shown in the project response so procurement and installation teams are not left to improvise after cutting.

  • Rubber-over-stainless-steel edging strip: identify the locations and estimated lengths required.
  • Slotted angle trim: confirm the profile and how it will be retained on the particular panel edge.
  • For either option, verify the fit, retention and final condition against the project’s approved drawing and site risk assessment.

The proposal describes these trims as intended to provide a safer, less abrasive finished edge. It does not provide dimensions, a test report or a claim that the trim removes every cutting hazard; the selected detail still needs engineering review.

A Design-Stage Checklist for the Three Project Roles

  • Designer: identify possible cut locations on the drawing, preserve access and clearance requirements, and specify the selected edge trim.
  • Project manager: include the agreed spare-part allowance and edge-protection quantity in the released BOM and packing list.
  • Sales manager: state the cutting assumption, excluded work and responsibility for site modification in the proposal scope.

This makes a potential field change visible while it can still be costed and coordinated. It also helps separate a planned adjustment from a late variation that could affect installation readiness.

Scope Note

The approximately 500 m quantity and the possible on-site mesh trimming come from one project proposal, not from a general Mdfence installation standard. The proposal does not define cutting tools, a universal spare-parts ratio, a site-cut tolerance or a complete edge-trim specification. Confirm those items against the released project drawings, site risk assessment and agreed scope before work begins.